ap-id (iot-device-type-imagotag-policy)

Configures an Access Point (AP) ID, allowing the SES-Imagotag server to identify individual Imagotag-enabled ExtremeWireless WiNG APs.

Note

On the Imagotag server, configure the ExtremeWireless WiNG AP's ID. This enables the server identify the AP. Use the show iot-device-type-imagotag status command to obtain the AP's ID. Refer to the Imagotag server configuration guide for more information.

Supported on the following platforms:

Access Points: AP360i/e, AP310i/e, AP410i/e, AP460i/e, AP505i, AP510i/e, AP560i, AP560h, AP3000/X, AP5010, AP5050
Service platforms: NX5500, NX7500, NX9500, NX9600
Virtual platforms: CX9000, VX9000

Syntax

ap-id <210000-219999>

Parameters

ap-id <210000-219999>


ap-id <210000-219999>	Enter a value in the range 210000 – 219999 that uniquely identifies the AP to the SES-Imagotag server.

Examples

vx9000-AA3AED(config-iot-device-type-imagotag-policy-CaroTest)#ap-id ?
  <210000-219999>  AP ID

vx9000-AA3AED(config-iot-device-type-imagotag-policy-CaroTest)#ap-id 210001

vx9000-AA3AED(config-iot-device-type-imagotag-policy-CaroTest)#show context
 iot-device-type-imagotag-policy CaroTest
  ap-id 210001

vx9000-AA3AED(config-iot-device-type-imagotag-policy-CaroTest)#no ap-id

Related Commands


no (iot-device-type-imagotag-policy)	Removes the configured ap-id.